Black Hole Vu+ Uno 2.0.2 Rev. A

hosseinIT

hosseinIT

Vu+ Newbie
herc said:
I am comming from 1.7.9 BH and this image is un useful for me because i can not load my personal back up.
Thx.
Click to expand...

I upgraded from 1.7.7. to 2.0.2 and after installing asked to restore my backup i did it and my personal backup restored without problem , I have motor too and all motor settings restored successfully !!! after that if encounter any problem with any sat. delete that sat. and add it again.
 
bogdanm

bogdanm

Moderator
hosseinIT said:
I upgraded from 1.7.7. to 2.0.2 and after installing asked to restore my backup i did it and my personal backup restored without problem , I have motor too and all motor settings restored successfully !!! after that if encounter any problem with any sat. delete that sat. and add it again.
Click to expand...
I think your backup made on 1.7.7 is very old and was made on OE1.6 now BH have O.E2.0 used backup from old image i think will be made alot of problem in new image.
I think best is install all from begined and made new backup this new backup will be good to used on next version image based on oe2.0.
 
Matrix10

Matrix10

Administrator
komodo1 said:
if i make reciver on night morrow i fin reciver off maybe shutdown is reason
Click to expand...

That I did not understand.

In general, you have two main options.

1.You're putting your receiver in Standby
But you want to go OFF after a certain time.

(Example >>Let's say over night you like to have receiver OFF/ShutDown)

2. Enable action after inactivity.

Example
You watch TV and fall asleep.
In this case, you can use this option to switch off the receiver.
 
F

furio11

Vu+ Newbie
why after pressing blue / yellow , i see the flash in the red at 89% after disabling hbbtv in fast boot , on a fresh usb update ? is this normal ?
 
D

dixons

Vu+ Newbie
Have just upgraded to 2.2.0 Rev A and would like to re install the On Demand plug in, but the above advice seems a bit vague, can you be a bit more precise on how you install the On Demand plug in using telnet.
Also why has it disappeared from the Add Ons . Love all the work on the BH image.
 
World Wide Soft

World Wide Soft

Vu+ Newbie
Can anybody please explain this:
You also will need to check for and remove any vuplus folders found on your hdd or usb devices before you install this image.

I am going to upgrade from 1.7.9 and I have some recordings and other stuff on my hdd. I'm not sure which folders I have to remove from my hdd. Which folders are vuplus folders and is my recordings safe if I upgrade? Thanks!
 
Mito

Mito

Administrator
World Wide Soft said:
Can anybody please explain this:
You also will need to check for and remove any vuplus folders found on your hdd or usb devices before you install this image.

I am going to upgrade from 1.7.9 and I have some recordings and other stuff on my hdd. I'm not sure which folders I have to remove from my hdd. Which folders are vuplus folders and is my recordings safe if I upgrade? Thanks!
Click to expand...
It means you have to remove (or simply rename) any folder named "vuplus".
 
You must log in or register to reply here.
Top