vu zero rev2

Mike2loco

Vu+ Newbie
Hello friends, I am trying to install the Black Hole 3.0.9.F Vu + Zero & Vu + Zero Rev.2.0 image and I am not getting it, do you know if any new firmware will come out?
 

Mick12334

Moderator
You can find the image here:
https://www.vuplus-community.net/board/threads/black-hole-3-0-9-f-vu-zero-vu-zero-rev-2-0.39702/

Download the image, and unzip it. Load the vuplus folder, onto a FAT 32 formatted USB stick.

Power off Vu+ Zero using the switch, at the rear of the receiver.
Insert the USB Pen Drive into the USB socket on the back.
Switch on Vu+ Zero.

The white LED, on the left side, of the front panel should begin pulsing, indicating that the image is loading.

Once the image has successfully loaded, the pulsing will stop and change to blinking on and off.

When the white LED is blinking, on and off, switch the receiver off, using the switch, at the rear, remove the USB stick, then power it up again.

At which point are you experiencing a problem?
 

aitormeteor

Vu+ Newbie
simplemente ami no me la carga no hace nada , y lo ago tal cual , en formato fat32 , enciendo pero no hace nada del led simple mente se enciende no la carga
 
The most common issue when you format an usb stick is that you dont set the "Allocation unit size" to default. But leave it to 4096 bytes
4096 bytes prepeare the usb stick for Windows, but default just format and does not prepare for any OS. This usally works for flashing.
 

Mike2loco

Vu+ Newbie
I used the same pen for other vu zero rev2 and I didn't have this problem, I already changed the pen and the problem remains
 
Now i am a bit confused :) They are identical but the power supply dont fit from one to the other??
And you can flash Original Software by that you refer to the stock Vu+ image??
 

Mike2loco

Vu+ Newbie
the power cable of the new vu zero ver2 is no longer the same, this is the only difference I see in the two, I can't flash the new one, it connects, but only connects with the original firmware
 

Mike2loco

Vu+ Newbie
UohHmTJC
https://mega.nz/file/UohHmTJC#c1HxToxlOy-Qlk6xyf9WpypPqmI2ZNNH16aBtPkMH30

the new one is yellow
 
Sorry did not read the thread from the start.
You have one Vu+ Zero and one Vu+ zero ver 2 that explains why there are diffrent power supply.
But still you can on the new install the Stock Vu+ image but not any other image. ??
Did you download the image from vuplus.com or have you got it with the new Vu+ zero?

Also have you try to flash the OpenBlackhole image?
 

Mike2loco

Vu+ Newbie
are the two vu zero rev2, but the power cable is different as you can see in the picture, the first one I bought was six months ago, the one I bought this week is that it comes with a different power cable, but it is a zero vu rev2.
 
Thats strange if they are identical models from Vu+ they should have the same power supply.
But have you try and flash anyother image then Blackhole? we also have the OpenBlackhole in any case is better suited for your zero
 

Mike2loco

Vu+ Newbie
I've tried different images, it just doesn't do anything, when it turns on it's the original firmware, I think I'll have to wait for a new update
 
Top