Vu+
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Linux commands for your Vu+ (for Dummies)

Discussion in 'Vu+ General HowTo & Guides' started by Madzo, Nov 8, 2017.

  1. jmdavet

    jmdavet Vu+ Newbie

    Messages:
    16
    I mean "I read it before the one you showed me"...
     
  2. Alexwilmac

    Alexwilmac Vip

    Messages:
    4,170
    The important is that you solved but, please, notice that "your" guide tells exactly the same things that ours does.
    As a matter of fact, also your guide says you have to decompress (that means unzipping) the installation file. Afterwards, you must copy the vuplus folder to the USB flash drive... ;)
     
  3. jmdavet

    jmdavet Vu+ Newbie

    Messages:
    16
    I'm sorry, but that was exactly wath i did .... before you gave me your splendid trick! And it seems that it did'nt work. I'will try again to check that.:)
     
  4. nunigaia

    nunigaia Moderator

    Messages:
    5,111
    So, to clarify, you haven´t flashed your Solo4K! :(

    Right?

    best regards
    nunigaia
     
    Thomas67 likes this.
  5. bogdan113

    bogdan113 Vu+ Newbie

    Messages:
    2
     
  6. bogdan113

    bogdan113 Vu+ Newbie

    Messages:
    2
    Turn off the receiver behind the receiver, insert the usb stick, and then restart the receiver from the back switch. After reflashing, stop the receiver swich, remove the stick and reboot it.
     
  7. nunigaia

    nunigaia Moderator

    Messages:
    5,111
    **** WARNING ****

    This is a satellite board for supporting Vuplus original STB´s regarding BlackHole and Open BlackHole images.

    External live links are not allowed on our board.

    Read our board rules --> https://www.vuplus-community.net/rules.html

    best regards
    nunigaia
     
    Last edited: Jun 2, 2019

Share This Page