Hi the tuner A has stopped working 0% signal coming out of it, i have flashed another image and it still dead
the box is vu+ duo and is genuine
Do you thing is that it?
Hi the tuner A has stopped working 0% signal coming out of it, i have flashed another image and it still dead
the box is vu+ duo and is genuine
Do you thing is that it?
Yes i i have checked lnb cables and i swap them around to no vain
and i connect that cable to dreambox 800hd i get a signal.
i know you can not replace the tuner because illok embeded in the motherboard, bad design
My tuner B ( Vu Duo) has stopped suddenly and no signal any more. I did follows:
- checked cable and dish alignment also LNB ,all were ok.
- I measured output voltage of tuner ( while active) no voltage! normally should have 13 or 18 volt
- I did a circuit test in tuner input B ( where cable is connected) and found problem because it was short circuit.
Does anybody knows about lack of voltage ? possible lock of tuner?
the tuner is working now, i found issue in the setting, in the tuner B it says increase voltage..........yes I change it to No as tuner A and voila back to life again.
Than you all of those who tried to help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.