Vu+
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Vu+ Zero CFE update

Discussion in 'Vu+ General HowTo & Guides' started by Mito, Mar 7, 2015.

  1. Mito

    Mito Administrator

    Messages:
    6,695
    If you have any problem with Ethernet on Zero, please update CFE.
    If your set is working properly, PLEASE DO NOT UPDATE IT!

    How to update the bootloader:

    1. Unzip the vuplus_zero_cfev1.04.zip to USB stick.(There should be /vuplus/zero/cfe_cfe_auto.bin)
    2. Insert USB stick into the USB port of Zero and turn the power on.
    3. It takes just a few seconds to update.
    4. If front LED of Zero displays blinking, remove the USB stick and restart the box.
    5. If the update of the Zero CFE has completed successfully, the LED will blink four times on reboot.

    PS: This Bootloader (CFE) should be used for Zero only. Otherwise it will crash the box.
     

    Attached Files:

    mohpower, ziadpoor and ramon48 like this.
  2. Fuzer

    Fuzer Vu+ Newbie

    Messages:
    3
    I there. I made the update and it worked fine. I coldnt conect very well to internet, after this update all works fine.
    Thanks.
    Compliments
     
    Mito likes this.
  3. ramon48

    ramon48 Vu+ Newbie

    Messages:
    7
    Tengo un Vu + Zero y tendrĂ© encuenta esto. por si tengo algĂșn problema. Gracias
     
  4. braouf

    braouf Vu+ Newbie

    Messages:
    2
    Thank you it work fine now
     
  5. vdias

    vdias Vu+ Newbie

    Messages:
    4
    How can i check what version is installed on my vu+ zero?
     
  6. angelofsky1980

    angelofsky1980 BlackHole Driver Specialist

    Messages:
    16,685
    Check how many blink your box led do.
    3 original version
    4 new version
     
  7. vdias

    vdias Vu+ Newbie

    Messages:
    4
    what? blink on boot?
     
  8. angelofsky1980

    angelofsky1980 BlackHole Driver Specialist

    Messages:
    16,685
    Yes. Blink on boot
     
  9. mohpower

    mohpower Vu+ Newbie

    Messages:
    3
    Hello,
    Can you tell me why i can do update CFE for my ZERO ?
    That necessary ? how to check it on my zero is v1.04 ?
    Thank You
     
  10. Mick12334

    Mick12334 Moderator

    Messages:
    1,957
    On the Duo 2 it's displayed on start up, if you switch off, at the rear, and watch the front panel, when you switch on, you can see the bootloader version.
    On other receivers you might see it in the menu information.
     

Share This Page