Hi guys,
so my motor has been acting more and more weird lately and before I start the long process of returning it I though someone here might have an idea what could be done.
I've measured the amps/volts and it seems to be ok, not 100% sure what it was since I didn't write down the exact numbes. I can get the sat to move using the 'positioner setup' tool.
My tuner is setup to use usals, but I've also tried to use positioning, both ways fail. So the only way I can get the motor to change sat is to
1. change chan
2. using the tool choose 'move west / east'
But I just can't get it to move when changing a chan.
Any tips what could be wrong? I've tried a new cable that's 8.6mm compared to the old 6 to see if it was a matter of loss of signal. Same result there. (using a 15m cable)
Motor type is an Opticum HH mh1.
so my motor has been acting more and more weird lately and before I start the long process of returning it I though someone here might have an idea what could be done.
I've measured the amps/volts and it seems to be ok, not 100% sure what it was since I didn't write down the exact numbes. I can get the sat to move using the 'positioner setup' tool.
My tuner is setup to use usals, but I've also tried to use positioning, both ways fail. So the only way I can get the motor to change sat is to
1. change chan
2. using the tool choose 'move west / east'
But I just can't get it to move when changing a chan.
Any tips what could be wrong? I've tried a new cable that's 8.6mm compared to the old 6 to see if it was a matter of loss of signal. Same result there. (using a 15m cable)
Motor type is an Opticum HH mh1.