How do I configure Solo2's Tuner A&B with 2 LNBs and a motor?

G

Giorgos

Vu+ Newbie
Hi,

I have a Solo2 with the following connection and configuration:

SOLO2 Connection:

1. My connection from Solo2, LNB1, goes to motor and then to LNB port 1 on the dish (motorised LNB port1)
2. My connection from Solo2, LNB2, goes directly to LNB port 2 on the dish.

My Tuner configuration is as follows:

1. Tuner A: Positioner: USALS
2. Tuner B: Second cable of motorized LNB Tuner A:

With the above connections and setup I can tune to any satellite using Tuner A only.

Can anyone help and/or advice how I can configure the two Tuners so that I can watch a channel from Tuner A and record from Tuner B?

As before, your help will greatly appreciated.

Kind Regards,

Giorgos
 
angelofsky1980

angelofsky1980

BlackHole Driver Specialist
Giorgos said:
Hi,

I have a Solo2 with the following connection and configuration:

SOLO2 Connection:

1. My connection from Solo2, LNB1, goes to motor and then to LNB port 1 on the dish (motorised LNB port1)
2. My connection from Solo2, LNB2, goes directly to LNB port 2 on the dish.

My Tuner configuration is as follows:

1. Tuner A: Positioner: USALS
2. Tuner B: Second cable of motorized LNB Tuner A:

With the above connections and setup I can tune to any satellite using Tuner A only.

Can anyone help and/or advice how I can configure the two Tuners so that I can watch a channel from Tuner A and record from Tuner B?

As before, your help will greatly appreciated.

Kind Regards,

Giorgos
Click to expand...

Setup should be correct.
About tuning, you can tune with A and start record with that tuner and see another DVB service from the same satellite with tuner B.
 
You must log in or register to reply here.
Top