HDMI CEG Setup

X

x-xxxA

Vu+ User
I'm trying to to have the TV on standby when the decoder is on standy and stwitch on TV when I switch on the TV. I have been trying to setup the HDMI CEG, but haven't succeeded. Now I have messed up the setup that have lost hope. I have OPB release 1.0.0.23. Any help will be appreciated.
 
AlexWilMac

AlexWilMac

Moderator
If you had googled a little bit for this problem, you'd found out that HDMI CEC is a protocol not perfectly adopted by every TVs.
Switching on TV when you switch on the STB is quite possible and common, as far as I know; putting in stand-by the TV when you put the STB in stand-by or deep s.b. is a completely different matter, unfortunately, and it depends on TV, not on STB or images.
 
X

x-xxxA

Vu+ User
I had it with OBH v1.0 but with earlier release than 1.0.0.23. Today I flashed it again and did upgrade to 1.0.0.23 and could it do it. Could be that the HDMI CEG is different than it was before.
 
You must log in or register to reply here.
Top