Probleme of Disecq c 1.2

[laplace]

Hello
I just bought a VU + duo.
I installed the image BH174 without problem.
By cons when I want to install a motorized dish I can not find
the parameters of commands DiSEqC1.2 same for the other images BH 170,172,173.
Could you help me find the solution to this problem.
Thank you in advance

 

[Matrix10]

Main Menu >> Setup>>Service Searching >>Tuner configuration.

For motorized DiSEqC dish you can use
Configuration mode simple
and put only Longitude and Latitude .

Of course you can use the advanced mode
but it is a bit complicated and you can chose DISEqC mode 1.2