SCR "Connected to" option disappeared in 4.4.010

[AlexWilMac]

I hadn't noticed until today but the option "Connected to" is now visible only where it must be set to no (in the case of Solo4K, tuners A and B).
It is not visible entering the setup ov FBC virtual tuners.
So I launched OpenVix, copied the config.nims lines from its "settings" file and used its lines under OBH.
Tuners works as intended but the "Connected to" option is not visible.
I suspect this happened after the update from 4.4.009 to .010 so I loaded a previous backup, and I was right: in the 009 release the options were at their place.

 

[AlexWilMac]

It also disappeared the Signal Finder screen. At least, this is in the Solo4K release, the only VU+ I've got where I can check these options. The other two don't have FBC tuners.

 

[AlexWilMac]

Issue solved after update to 4.4.011