Duo2 Switching ON from a deep-stanby using remote controll

jwlalek

jwlalek

Vu+ User
vic said:
So if I do it in sort period of time it work ok, but if left it a long time in Deep Stb, do not power up with remote.
jwlalek ------ Can you check it in your box,pls ????? -
Click to expand...

I haven't noticed that kind of problem.

Eragon said:
I usually can power on the Duo2 with the remote after almost 20 hours of deep standby (for example power off at 01:00, power on at 21:00)
Click to expand...

This is exactly same what my receiver does.
 
vic

vic

Vu+ Newbie
OK. This morning ( after 13 hours in Deep Standby), machine power up correctrly with the remote control. Thas the he has to do. OK.

Action done yestaeday before this, was: in BH Speed Up, disable the Remote Control Code plugin, restart GUI and after that enable the plugin again. Restarted GUI and some hours later, power off ( Deep Satndaby).
This morning , as said before , power up correctly.
So for my is OK . Thaks a lot to everey one.
 
D

Dima73

Vu+ Newbie
You find it perfectly normal?
That without installing additional plug-in receiver is not activated with the remote control!!!
 
Eragon

Eragon

Vu+ User+++
Dima73 said:
That without installing additional plug-in receiver is not activated with the remote control!!!
Click to expand...
In BH that plugin is installed and activated at startup by default.

Apparently it's required to resume the box with the remote only from deep standby.
Otherwise it could be deactivated or uninstalled, but honestly I can't find good reasons to do so.
 
You must log in or register to reply here.
Top