VU+ Zero - intermittent SNR

[tEaM]

Hello.
I need your help. I bought a used VU+ ZERO, but I can not configure it correctly for the Hispasat 30W-4/30W-5 (30.0W) satellite. I programmed the VU with the "BlackHole-3.0.3" image, and set everything up.
But the SNR signal is oscillating between 0% and 99%. While the AGC is 82%. The antenna and LNB are new and I've tested it with another box from another brand and it works perfectly.
Is it a configuration problem or a hardware problem?

Thanks for your help.
Regards

 

[Mick12334]

Your images show a frequency of 11836, and I can't see a 11836 H 27500, on 30W.
Try one of the frequencies listed on lyngsat:

https://www.lyngsat.com/Hispasat-30W-4-30W-5.html

 

[tEaM]

@Mick12334
Thank you very much for your help.
I'm a beginner in this device's settings. It's my first experience in BlackHole images.

Now I repeated the test with the frequency of a Portuguese provider:


And the result is more positive and ... stable! Now it does not swing to 0%. It is always in the 59%.


But I have one more question. I did a Service Scan on this frequency and found no services found. It's normal?



Thanks for your help.
Regards.

 

[Mick12334]

Your signal quality levels are quite low, depending on your general location, and size of dish, but you should be able to scan some channels in.
Try a few different frequencies:
12399 H 27500 DVB-S2 8PSK 3/4
12380 V 27500 DVB-S
11771 V 27500 DVB-S

 

[tEaM]

Thanks, @Mick12334
Tonight I'm going to test those different frequencies...

 

[tEaM]

@Mick12334,
I tested these frequencies and the results were as follows:

Freq.: 12399, SNR: 59%


Freq.: 12380, SNR varies between 0%, 16% and 43%




Freq.: 11771, SNR: 0%


They are not very good results...

Regards

 

[Mick12334]

Did you manage to scan in any channels?
Go to manual scan, enter the 12399 H 27500 DVB-S2 8PSK 3/4 and try scanning in some channels.
If that fails try doing a blind scan, and see if any channels scan in.
You might not be aligned, on 30W, or at least the dish might not be fully aligned.

 

[tEaM]

0 services found...

 

[tEaM]

But I have signal, because if I connect another box works without problems...

 

[Mick12334]

What other receiver are you connecting and what channels can you view?
Your signal quality readings are very poor, at least on the VU+ Zero, so what signal quality readings do you have on your other receiver?
How have you set the tuner up, in the menu, on your VU+ Zero?
Can you get BBC World News on 11771 V 27500 DVB-S, and 12476 H 27500 DVB-S2 8PSK 3/4?
Please post the names, of the channels, and frequencies, that you can get on your other receiver.

 

[wgnrblay]

Try scrolling down and see if it allows to press lock should stabilise after that.

Sent from my SM-G935F using Tapatalk