cyborgpunte
Vu+ User
Hi, Couldn't resist buy this one when I was shopping 2 quad LNB and switch (other thread)
But it causes me problem:
From the begining I saved my "latast good knowned configuraton"
But I was so confused. So I nailed it down ;
When I start with a newly flashed Solo2 ((with a clean BlackHole-2.0.1-vusolo2_usb))
Solo2 is equipped with internal HD, external powered USBhub.
In this hub also HD, WiFi and a memory stick.
Same symptom everywhere I put the 290e, but I prefer the hub.
BTW the DVB-T stick is working OK in windoze enviroment.
1:st start after flash, the 290:e is discovered by system,
and it works to scan manual, automatic and one transponder on DVB-T
I have tried several sat, config but I atm uses a= simple b= passtrough
And I can look on FTA both SD and HD.
BUT after reset/restart/powercycle
I got this symptom
Check tuner errormezz on all T-channel that worked before the restart.
The Solo2 still claims that he has a 290e installed, so that is correct.
If I try to scan I got "error starting scanning"
please, help me out here
TIA
But it causes me problem:
From the begining I saved my "latast good knowned configuraton"
But I was so confused. So I nailed it down ;
When I start with a newly flashed Solo2 ((with a clean BlackHole-2.0.1-vusolo2_usb))
Solo2 is equipped with internal HD, external powered USBhub.
In this hub also HD, WiFi and a memory stick.
Same symptom everywhere I put the 290e, but I prefer the hub.
BTW the DVB-T stick is working OK in windoze enviroment.
1:st start after flash, the 290:e is discovered by system,
and it works to scan manual, automatic and one transponder on DVB-T
I have tried several sat, config but I atm uses a= simple b= passtrough
And I can look on FTA both SD and HD.
BUT after reset/restart/powercycle
I got this symptom
Check tuner errormezz on all T-channel that worked before the restart.
The Solo2 still claims that he has a 290e installed, so that is correct.
If I try to scan I got "error starting scanning"
please, help me out here
TIA